Re: How to get tether to work (solved)

[ooseven]

$ ifconfig -a
eth0      Link encap:Ethernet  HWaddr bc:ae:c5:d9:b7:ca 
          inet addr:192.168.0.4  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::beae:c5ff:fed9:b7ca/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3691 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2970 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:3380406 (3.3 MB)  TX bytes:422360 (422.3 KB)

lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:833 errors:0 dropped:0 overruns:0 frame:0
          TX packets:833 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:71508 (71.5 KB)  TX bytes:71508 (71.5 KB)

usb0      Link encap:Ethernet  HWaddr 82:68:04:d8:56:3f 
          inet6 addr: fe80::8068:4ff:fed8:563f/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:6179 (6.1 KB)